Created a quickly removeable cover for the SRS platform. To help you make your own made a pattern with approximate sizes and instruction.

I used a stichwork of leftover Phantomleaf mesh pieces, to figure out shapes and sizes. You can use any mesh, or probably any other camouflage fabric, but mesh may would work better to add 3D elements later.

On the inside it has a framework of webbing, I used 20mm binding tape, it was also leftover from my ghillie buld, you can use any other kind of webbing ideally 20-30mm wide.

The pattern shows the aproximate palcement of velcro hook and loop pieces. The loop pieces attached with elastic webbing to add tension for the cover.

Keep in mind this pattern just aproximate, and you may have to adapt it to your own rifle, if you have any attachments or more stock pads for example.

Other than that, since it’s made for a right hand 16″ version, if you have lefthanded one just just the hole for for bolt on the other side, if you use 22″ just add a bit of fabric to the front section.

Have fun if you build your own one and don’t forget to share photos of it.

Stay tuned!